Monarch 1828 Specifications.

AMD Dual Opteron server motherboard, proprietory form factor

AMD® Opteron® Model 2XX processors, .13 or .09 micron, 1M L2 cache, Socket 940, single core
AMD® Opteron® Model 26X/27X/28X processors, .09 micron, 2M1 L2 cache, Socket 940, dual core
64-bit integer registers, 128-bit SSE/SSE2 registers
48-bit virtual addresses, 40-bit physical addresses
AMD 64-bit x86 instruction set extensions

Nvidia nForce Pro 2200 and 2050 HyperTransport I/O Hubs
AMD 8132 HyperTransport PCI-X 2.0 Tunnel
Dual channel UltraDMA/133 bus mastering IDE controllers

Memory Subsystem:
Sixteen DIMM banks supporting up to 16GB DDR400 or 64GB DDR333 ECC registered SDRAM memory
Dual channel (128-bit) memory bus supporting 11.4 GB/s (DDR333) or 12.8 GB/s (DDR400) accumulated memory bandwidth

Note: To enable 128-bit memory bus, memory modules must be populated in pairs.
Note: To enable NUMA, a minimum of four modules are required.

Graphic Subsystem:
Integrated ATI Rage XL with 8MB SDRAM

Hard Disk Subsystem:
(1828-T) Up to two Serial ATA hard drives in capacity from 80GB to 750GB. These drives can be configured as standalone unit or disk array(s) using the Linux software RAID.

(1828-S) Up to two Ultra 320/m SCSI hard drives (SCA/80-pin) in capacity from 36GB to 300GB. These drives can be configured as standalone unit or disk array(s) using the Linux software RAID.

SCSI Subsystem:
(1828-T) Onboard nForce4 Serial ATA II controller

(1828-S) Onboard Adaptec 7902W dual channel Ultra 320/m SCSI controller, 64-bit/100mhz PCI-X

CD-ROM Subsystem:
24X Ultra DMA/33 slim CDROM reader

Sound Subsystem:

Network Subsystem:
Two onboard Broadcom BCM5721 PCI-Express Gigabit controllers, 1000BaseTX
Onboard in-band and out-of-band remote server management over LAN, IPMI 2.0

System Slots:
One (1) 64-bit/133mhz bus mastering PCI-X slot2, half-length only
One (1) 64-bit bus mastering PCI-E x16 slot, half-length only

System I/O:
One (1) RS-232C 16550 serial port
Two (2) USB 2.0 ports (rear panel)
Two (2) USB 2.0 ports (front panel)
One (1) PS/2 Mini DIN keyboard/mouse port
One (1) 15-pin VGA port
Two (2) RJ-45 ports
One (1) Firewire 1394a port
(1828-S) One (1) VDHCI SCSI port (SCSI channel B)

Floppy Drive:



ASL 1U Rack mount chassis, FCC Class B
500W EPS12V power supply with PFC
Dimensions: 1.7" (H) x 16.9" (W) x 27.5" (D)
One (1) accessible slim size CDROM bay
One (1) accessible slim floppy drive bay
(1828-S) SCA backplane supporting two hotswap Ultra 320/m drives (80-pin), SCSI channel A
(1828-T) SATA backplane supporting two hotswap Serial ATA drives
Two (2) high performance system blowers
Copper-based passive heatsinks and air baffle for the processors
Sliding rails kit with telco mount support
Power, LAN1, LAN2, System Fail, and System ID LED

Preinstalled Software:
Red Hat 32-bit or 64-bit Linux with ASL optimized kernel

  1. Each processor core has 1M L2 cache.
  2. Slot is incompatible with 5V PCI add-on card.
Phone: 1.877.ASL.3535